When your application requires a simple threaded assembly, the Tuf-Grip SW-702 Threaded Stud is the most economical choice.

You can depend on the tolerances with this assembly. The standard stud material is carbon steel, but stainless steel and higher strength steels are also available. We furnish the studs without wrench flats unless specified on the order, as discussed above.

When measuring the thread length, use the minimum dimensions to make use of existing qualified designs. Thread length may be increased if desired. The standard thread used is Right Hand National Coarse Class 2A, but other threads are available on request.

The L, and D fitting dimensions are needed, along with the maximum length of the assembly measured using the outside end of the stud.

Custom designs with different fitting lengths and thread diameters are available, but that may reduce the assembly's rated capacity. Please check with our customer service department.